The limiting reactant in a chemical reaction is the substance that is completely consumed in the reaction, thus limiting the amount of product that can be formed. It determines the maximum amount of product that can be produced in a reaction. The presence of a limiting reactant is important because it allows chemists to calculate the theoretical yield of a reaction, which is the maximum amount of product that can be obtained under ideal conditions. Identifying the limiting reactant is crucial for determining the most efficient way to carry out a reaction and for understanding the stoichiometry of the reaction. **

The reactant in the combustion of a candle is the wax or paraffin in the candle. When the candle is lit, the heat from the flame melts the wax, which is then drawn up the wick and vaporized. This vaporized wax then reacts with oxygen in the air, leading to the combustion process that produces heat, light, and carbon dioxide. **

In a redox reaction, the reactant side consists of the substances that are being oxidized and reduced. The substance being oxidized loses electrons and is therefore the reducing agent, while the substance being reduced gains electrons and is the oxidizing agent. On the product side, the oxidized and reduced substances form new compounds as a result of the transfer of electrons. The products of a redox reaction are the new compounds formed after the transfer of electrons between the reactants. **

When a reactant cools down during a reaction, it indicates that the reaction is endothermic. This is because the reactant is absorbing heat from its surroundings, causing its temperature to decrease. In an exothermic reaction, the reactants release heat to the surroundings, causing an increase in temperature. Therefore, a cooling reactant suggests an endothermic reaction. **

To apply a new waterproofing membrane on top of an old bitumen waterproofing membrane, the surface of the old membrane should be thoroughly cleaned and prepared. Any loose debris, dirt, or old adhesive should be removed to ensure proper adhesion of the new membrane. Once the surface is clean, a primer should be applied to promote adhesion between the old and new membranes. Finally, the new waterproofing membrane can be installed according to the manufacturer's instructions, ensuring that it is properly sealed and bonded to the old membrane to provide effective waterproofing. **

A reactant is considered as an acid when it donates a proton (H+) in a chemical reaction. Acids are characterized by their ability to increase the concentration of H+ ions in a solution. On the other hand, a reactant is considered as a base when it accepts a proton (H+) in a chemical reaction. Bases are characterized by their ability to decrease the concentration of H+ ions in a solution. The classification of a reactant as an acid or a base depends on its behavior in a specific chemical reaction. **

A utility knife or a sharp blade is typically used to cut the waterproofing membrane. It is important to use a sharp tool to ensure clean and precise cuts, which will help in achieving a proper seal and prevent water leakage. Care should be taken to avoid damaging the underlying surface while cutting the membrane. **

When the equilibrium is on the product side, it means that the forward reaction is favored, and the concentration of products is higher than that of reactants at equilibrium. Conversely, when the equilibrium is on the reactant side, it indicates that the reverse reaction is favored, and the concentration of reactants is higher than that of products at equilibrium. The position of the equilibrium can be influenced by factors such as temperature, pressure, and concentration of reactants and products. **