Grouting should be done after the tile adhesive has set and the tiles are firmly in place. This typically takes about 24-72 hours, depending on the type of adhesive used. It is important to wait until the adhesive has fully cured to ensure that the grout will adhere properly and provide a strong, durable finish. Additionally, grouting should be done when the weather conditions are suitable, as extreme temperatures or humidity can affect the grout's performance. **

Cement mortar with a mix ratio of 1:3 (1 part cement and 3 parts sand) is commonly used for tile grouting. This type of mortar is suitable for filling the gaps between tiles and providing a strong, durable bond. It is important to ensure that the mortar is mixed to the correct consistency and applied properly to achieve a smooth and even grout finish. **

To apply a new waterproofing membrane on top of an old bitumen waterproofing membrane, the surface of the old membrane should be thoroughly cleaned and prepared. Any loose debris, dirt, or old adhesive should be removed to ensure proper adhesion of the new membrane. Once the surface is clean, a primer should be applied to promote adhesion between the old and new membranes. Finally, the new waterproofing membrane can be installed according to the manufacturer's instructions, ensuring that it is properly sealed and bonded to the old membrane to provide effective waterproofing. **

A utility knife or a sharp blade is typically used to cut the waterproofing membrane. It is important to use a sharp tool to ensure clean and precise cuts, which will help in achieving a proper seal and prevent water leakage. Care should be taken to avoid damaging the underlying surface while cutting the membrane. **

If the mortar dries on the tile while grouting, you can try using a damp sponge to gently wipe away the dried mortar. Be careful not to apply too much pressure as you may scratch the tile surface. If the mortar is stubborn and does not come off easily, you can try using a commercial grout haze remover following the manufacturer's instructions. It's important to act quickly before the mortar fully sets to make the cleaning process easier. **

Grouting is typically not included in the fixed price after the installation of doors. Grouting is a separate process that involves filling the gaps between tiles or other materials, and it is not directly related to the installation of doors. Therefore, it is usually not included in the fixed price for door installation. Customers may need to arrange for grouting separately or inquire with the installation service provider for additional costs. **

The drying time of the tile adhesive must be waited for before grouting because grouting too soon can disrupt the bond between the tiles and the adhesive. If grouting is done before the adhesive is fully dry, it can lead to the tiles shifting or becoming loose over time. Allowing the adhesive to fully dry ensures a strong and durable bond between the tiles and the substrate, resulting in a long-lasting and stable tile installation. **

Ideally, the waterproofing membrane should be applied in dry weather to ensure proper adhesion and effectiveness. If the membrane is applied and then it rains before it has fully cured, it can compromise its ability to create a watertight seal. Water exposure during the curing process can lead to delamination, reduced adhesion, and potential leaks. Therefore, it is best to apply the waterproofing membrane when there is no rain in the forecast and allow it to fully cure before any water exposure. **